Scaffolding Accessories: Rolling Towers
Rolls has Rolling Scaffolds that can be configured from 3'
to 30' high. Rolls has the component parts assemble a scaffold and
the needs of your task.
Small units such as Baker Scaffolds, Speedtowers and Reddi-Rolls
are available for your use.
Steel Rolling Scaffolds
Frames are 30", 3' and 5' wide by 2', 3', 4', 5' and 6'6" high.
Single box denotes rungs on only one side of frame. Double box denotes
rungs running across frames. Rolling scaffolds height is increased
by simply adding more frames to scaffold. Each section consists of
2 frames and 2 crosses.
COMPONENTS: Standard crosses are usually 7 feet
or 10 feet long.
GOOSERS: One diagonal brace across base of scaffold (gooser)
is required to prevent racking. On high scaffolds over 20 feet additional
are required. Check federal and local safety codes.
CASTERS: 8" rubber tired (500 lb.) casters that lock on the
wheel and stem are recommended.
SCREW JACKS: Screw jacks are optional. If you
require an exact height, the screw jacks will give you that adjustment.
If your work is overhead, on ceilings or ducts, the screw jacks
will pay for themselves in a short time.
GUARD RAILS: Guard rails are required as
specified by the (OSHA) federal safety regulations. Scaffold illustrated
requires 4 frames, 4
crosses, 1 gooser, 4 guard rail posts - 8 guard rails, 4 screw jacks,
four 8" casters and toeboards.
IMPORTANT RULE - When assembling a rolling
tower, ALWAYS USE HORIZONTAL BRACES on the frame section. This prevents
the tower from "racking" (getting
out of square). Horizontal braces must be used at the bottom and at every
20' height on rolling towers measured from the rolling surface.
Fast, easy assembly of standard components into any size or type of rolling
Wide range of accessories permit assembling a tower
to meet any working requirement or job condition.
If there is anything we can help or advise you on don't hesitate
to contact a Rolls representative. Our goal is to assist you in
getting your job done safely and economically.